Steel Metal Buildings by Olympia Steel Buildings Systems

Drafting and Detailing
The team of engineers and draftsmen utilize advanced CAD-CAM software created exclusively for the steel buildings industry. The factory engineers ensure that all buildings are engineered to meet or exceed local U.S. metal buildings codes, including snow load, wind speed and seismic requirements. Expert engineers on staff can provide stamped and certified permit drawings for every state in America including Hawaii and Alaska.

Permit drawings include:

• cover sheet with design loads and drawing index
• anchor bolt drawings
• column reactions
• rigid frame elevations
• side wall framing
• end wall framing
• roof framing, which includes sheeting drawings for side walls and end walls
• detail drawings

NOTE: Foundation drawings are not included, however, they are available for small fee from an outside concrete engineering firm. If full-scale calculations are required, they are available for a small fee.

CNC Technology
The steel building factory utilizes Computer Numerically Controlled (CNC) technology to create the highest quality secondary steel framing on the market today. The CNC machines use streams of digital information from CAD-CAM outputs to move motors and other positioning systems to cut, roll form and pre-punch bolt holes in steel components. Automated CNC technology enables the steel building factory to produce higher quality components in less time than competitors and pass substantial savings on to you.
 

Girt and Purlin Production
Every girt and purlin produced in the steel building factory is galvanized with a zinc coating which seals the surface of the steel to prevent rust. Unlike many steel buildings manufacturers, this rust-prevention treatment is standard all buildings we sell at no additional cost.  

Welding Department
The steel building factory certified welders utilize the latest gas metal arc welding (GMWA) technology. The advanced twin-arc submerged welding system used is capable of manufacturing structural steel components up to 72 inches deep allowing the production of column-free buildings interiors up to 200 feet wide. All welded components must pass strict quality control requirements.  

Trim Department
Many steel building manufacturers bend building eaves and trim by hand resulting in poor quality and substandard workmanship. The steel building factory trim department utilizes ten specialized roll forming machines to bend and form building eaves and trim. Many competing steel buildings manufacturers buy gutters and downspouts from other suppliers. The steel building factory has the machines and technology to manufacture gutters and downspouts, allowing the factory to strictly control quality, avoid the costs of buying components from other suppliers and pass substantial savings along to you.